Manual Hub Conversion

FAQ: Manual Hub Conversion

[toggler title=”Why is ORS’s kit better than the competition?”] Our competition does not include new wheel bearings in their manual hub conversion kits. Contrary to what is said, these bearings are NOT re-useable and must be replaced for safety when doing this swap. Our kits also come with the large snap rings that retain the […]

Continue reading
Manual Hub Conversion

Manual Hub Conversion

Most late model Toyota vehicles are equipped with an Automatic Differential Disconnect system, also known as ADD. These vehicles include ‘95.5 – ’04 Tacomas, ’96-’02 4Runners, ’00-’06 Tundras, and ’01-’07 Sequoias. Instead of conventional manual lockout hubs at the ends of the front axle, this system uses a shift fork at the front differential to […]

Continue reading
Aisin Hub Lockout Kit

Aisin Hub Lockout Kit (ORS-HB120)

The Aisin lockout kit should include the following: Aisin lockout body x 2 Aisin lockout cover x 2 Cover bolt x 12 Tapered cone washer, 8mm x 12 Flat washer, 8mm x 12 Nut, 8mm x 1.25 x 12 Retaining bolt w/ large washer x 2 If the hub body and cover are assembled, separate […]

Continue reading
High Angle CV Boot Kit

High Angle CV Boot Kit (ORS-HB201)

Thank you for purchasing our High Angle CV Boot Kit! Notice to customer: There is no warranty on the ORS High Angle CV Boot Kit. This High Angle CV Boot Kit is designed to reduce CV boot wear in high angle situations. This part is not designed to fit in the same manner as the […]

Continue reading
Manual Hub Conversion

Manual Hub Conversion Kit (Full Kit)

ORS-HB001/HB002/HB003 NOTICE: It is highly recommended that a qualified technician install this kit. Special tools/equipment are required for the installation. Experience with these procedures, particularly pressing wheel bearings, is highly recommended. Improper installation will void the warranty on these parts; this is the responsibility of whoever purchases this kit. NOTICE TO CUSTOMERS USING A LIFT […]

Continue reading
Manual Hub Conversion

Manual Hub Conversion Kit (Basic Kit)

ORS-HB051/HB052/HB053 NOTICE: It is highly recommended that a qualified technician install this kit. Special tools/equipment are required for the installation. Experience with these procedures, particularly pressing wheel bearings, is highly recommended. Improper installation will void the warranty on these parts; this is the responsibility of whoever purchases this kit. This kit does not include lockouts […]

Continue reading