NOTES: Be sure to read and fully understand these instructions before starting the installation process. These hoops are designed to run a shock with about 13” of travel on a vehicle with approximately 3-7” of lift. Proper shock length is determined by spring travel, vehicle use, and the placement of the bumpstops relative to ride […]
Continue reading
NOTES: Be sure to read and fully understand these instructions before starting the installation process. These hoops are designed to run a shock with about 13” of travel on a vehicle with approximately 3-7” of lift. Proper shock length is determined by spring travel, vehicle use, and the placement of the bumpstops relative to ride […]
Continue reading
NOTES: Be sure to read and fully understand these instructions before starting the installation process. These hoops are designed to run a shock with about 12-14” of travel on a vehicle with approximately 3-7” of lift. Proper shock length is determined by spring travel, vehicle use, and the placement of the bump-stops relative to ride […]
Continue reading
NOTICE TO CUSTOMER: The quality, strength, fit, and finish of this product is the responsibility of the installer and/or customer. This is a weld-on kit intended for experienced and competent fabricators with at least a basic knowledge of suspension fundamentals. This brackets are intended to be MIG or TIG welded (using at least a 220 […]
Continue reading
Remove all the IFS brackets, being careful around the motor mounts, as they will likely need reinforcement. Assemble the supplied jig, bolting it together with the ¼” bolts. When assembled, the 18mm holes, center to center is 43.5”. The “hook” end of the jig is used at the rear, to get around the body […]
Continue reading