The Aisin lockout kit should include the following:
- Aisin lockout body x 2
- Aisin lockout cover x 2
- Cover bolt x 12
- Tapered cone washer, 8mm x 12
- Flat washer, 8mm x 12
- Nut, 8mm x 1.25 x 12
- Retaining bolt w/ large washer x 2
- If the hub body and cover are assembled, separate these pieces.
- Lightly coat all inside surfaces with a multi-purpose wheel bearing grease.
- Install the hub gasket (provided w/ conversion kit) and lockout body onto the hub.
- Install the tapered cone washers, flat washers, and 8mm nuts onto the studs in that order. Tighten the nuts in a criss-cross pattern to 23 ft-lb.
- Install the snap ring on the axle shaft (provided with the conversion kit).
- Install the retaining bolt with large washer in the end of the axle shaft and tighten.
- Install the gasket and hub cover. Install and tighten the hub cover bolts to 7 ft-lb.
